www.davidson.com.au - Elcometer Inspection Equipment

The key feature of the Elcometer 236 is in the range of inspection accessories that are available. From carbon infused rubber used for inspections on delicate coatings, to rolling springs for external pipeline inspection, Elcometer has an accessory for your requirement.

PDF Datasheet | Request Info

TELESCOPIC PROBE HANDLE Glass fibre, fully insulated behind the ring, this low cost telescopic probe handle has been designed to allow the user to reach high areas from the ground or a platform. Using a simple twist and lock procedure the user can extend the handle to any length between the minimum and maximum.		EXTENSION PIECES To extend the probe for applications where a long reach is required, ideal for internal pipe inspection. Screw in the two pieces into the coupling piece and extend as far as you need to.
BAND BRUSH PROBE Provided as standard when an Elcometer 236 is purchaced, it is an ideal accessory for complex shapes, small products and for accessing drill holes, eyes, etc		RIGHT ANGLE WIRE BRUSH PROBES Manufactured out of Phosphor Bronze these wire brush probes are ideal for testing large, flat surfaces. A range of widths are available.
RIGHT ANGLE CARBON INFUSED RUBBER PROBES Ideal for testing large, flat surfaces with either thin or delicate coatings. A range of widths are available.		EXTERNAL PIPE ROLLING SPRING PROBES Designed specifically to measure the external diameter of pipes. A range of external diameters are available.
INTERNAL PIPE WIRE BRUSH PROBES Designed specifically to measure the internal diameter of pipes. A range of internal diameters are available.	(no picture available)	EXTERNAL DIAMETER PIPE TESTING KIT The Elcometer External Diameter Pipe Testing Kit has been created specifically to allow the pipeline inspector to create probes for non standard pipe sizes. Each kit allows the user to create either 1 external spring for use on a 635mm (25�) diameter pipe, or up to 3 springs of User defined diameters. Larger diameters can be made by connecting additional spring lengths together. Spring lengths can be purchased separately using the part numbers listed above.